This device is a product of the KNX system and
corresponds to the KNX guidelines. Detailed
specialised knowledge obtained from KNX training
is required for understanding. The planning, installation
and commissioning of the device is carried
out with the help of KNX-certified software.
system link commissioning:
The function of the device is software-dependent.
The software is to be taken from the product
database. You can find the latest version of the
product database, technical descriptions as well
as conversion and additional support programmes
on our website.
easy link commissioning:
The function of the device is configuration dependent.
The configuration can also be done using devices
developed specially for simple setting and start-up.
This type of configuration is only possible with devices
of the easy link system. easy link stands for
easy, visually supported start-up. Preconfigured
standard functions are assigned to the in/outputs
by means of a service module.
The device has four load outputs that can be connected
to different phases. It works with automatic
load detection depending on the connected load
in the phase cut-on or phase cut-off and enables
switching and dimming via the KNX bus of:
Incandescent lamps and halogen lamps
Low-voltage halogen lamps with conventional
or electronic transformer
dimmable LED and energy-saving lamps
Additionally, the device has a learn function for
more efficient control of energy-saving lamps and
230 V LED lamps.
Status display of the output on the device
Manual activation of the output on the device
possible, building site operation
Automatic load detection
Setting the minimum and maximum dimming
Forced position by higher-level controller
Combination of the outputs to dim more power
Short-circuit and overload protection
Short-circuit and overload are signalled via the
control LED. The load is throttled (see Troubleshooting).
Overheating of the device is signalled by a permanent
light of the control LED. The connected
load is throttled (see Troubleshooting).