This device is a product of KNX system and corresponds
to the KNX guidelines. Detailed specialised
knowledge obtained from KNX training courses
is required for comprehension. The planning,
installation and commissioning of the device is
carried out with the help of KNX-certified software.
The function of the device is software-dependent.
The software is to be taken from the product
database. You can find the latest version of the
product database, technical descriptions as well as
conversion and additional support programmes on
The function of the device is configuration-dependent.
The configuration can also be done using
devices developed specially for simple setting and
This type of configuration is only possible with
devices of the easylink system. Easylink stands for
easy, visually supported start-up. Preconfigured
standard functions are assigned to the in/outputs
by means of a service module.
The device has a load output. It works with automatic
load detection depending on the connected
load in the phase cut-on or phase cut-off and enables
switching and dimming via the KNX bus of:
incandescent lamps and halogen lamps.
Low-voltage halogen lamps with conventional
or electronic transformer.
Dimmable LED and energy-saving lamps.
Additionally, the device has a learn function for
more efficient control of energy-saving lamps and
230 V LED lamps.
Dimming of electric consumers AC 230 V.
Installation on DIN rail according to
DIN EN 60715 in distribution box
Status display of the outputs on the device.
Manual activation of the outputs on the device
is possible, building site operation.
Automatic load detection.
Setting the minimum and maximum dimming
Forced position by higher-level controller.
Short-circuit and overload protection
Short-circuit and overload are signalled via the
control LED. The load is throttled.
Overheating of the device is signalled by a permanent
light of the control LED. The connected
load is throttled.